Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the screen display and speaker volume
For analog signal
1.First perform an automatic adjustment. (p. 16)
2.Perform manual adjustment where necessary.
(p. 17)
For digital signal
The monitor can generally be used without
adjustment. If necessary perform manual
adjustment. (p. 20)
Note:
- All adjustments will be saved even after turning
the power off.
Resetting all adjustment values
All adjustment values can be returned to their
original ex-factory values in one command.
1. Turn off the monitor power.
2. Press the MENU button and the
button simultaneously, and while doing this press
the power button (i.e. turn the power on).
Continue to press the buttons until [ALL RESET]
appears on the screen. Reset is complete when
the displayed message disappears.
Notes:
- While [ALL RESET] is displayed, the control
buttons are disabled.
- It is not possible to reset values when the
adjustment lock is in place. Remove the
adjustment lock before attempting to operate
control buttons.
ADJUSTMENT menu reset
Settings of items in the ADJUSTMENT Menu
(CLOCK, PHASE, H-POS, V-POS) can be returned
to their original ex-factory values.
1. Turn on the monitor power.
2. Press the MENU button and the
simultaneously. When [RESET] appears on the
screen, the reset is complete.
Note:
- It is not possible to reset values when the
adjustment lock is in place. Remove the
adjustment lock before attempting to operate
control buttons.
Adjustment lock function
By disabling the control buttons (i.e. setting the
lock) any attempted changes to adjusted values will
be voided.
1. Turn off the monitor power.
2.While pressing the MENU button, press the
power button (i.e. turn the power on).
[ADJUSTMENT LOCKED] will appear on the
screen, and the lock will be set.
Note:
- When the lock is in place, all buttons other than
the power button are disabled.
Adjustment lock release
1. Turn off the monitor power.
2.While pressing the MENU button, press the
/ MODE
power button (i.e. turn the power on).
[ADJUSTMENT UNLOCKED] will appear on the
screen, and the lock will be removed.
Adjusting the backlight
1. Without the OSD Menu being displayed, press
the
2.Check that [BRIGHT] is selected.
If it is not selected, press the
and select [BRIGHT].
3. Adjust by pressing the
button (lighter).
Note:
- On Screen display for adjustment disappears
button
several seconds after the last operation.
14
or the
button.
VOLUME
80
BRIGHT
31
SELECT ... [
button (darker) or
/ MODE]
/ MODE button
Publicidad
