Sharp LL-T17D3 Manual De Funcionamiento página 13

Connecting the monitor and turning the monitor on and off
Turning the power on
1.Press the monitor's POWER button.
2.Turn on the computer.
The power LED will be lit green, and the screen
will display an image.
Press power button
Notes:
- When using an analog signal, perform an
automatic screen adjustment under the following
conditions:
- Using the monitor for the first time.
- After having changed the system settings
during use.
- Depending on the computer or OS, it may be
necessary to use the computer to install monitor
set-up information. If so, follow the steps below to
install the monitor set-up information.
- When connecting to a notebook, if the notebook
computer's screen is set so that it is displaying at
the same time, the MS-DOS screen may not be
able to display properly. In this case, change the
settings so that only the monitor is displaying.
Changing between input terminals
Use the INPUT button to switch between signal
input terminals.
Turn on the
computer
ON
Note:
- When there is no input signal, [NO SIGNAL] is
displayed.
Turning the power off
1. Turn the computer off.
2. Press the monitor's POWER button.
The Power LED will disappear.
If the monitor is not going to be used for a long
period of time, be sure to unplug it from the AC
outlet.
13
Analog RGB input
terminal
INPUT
INPUT-1
<ANALOG>
The input signal type (ANALOG/DIGITAL) is
displayed within angle brackets < >.
Turn the
computer off
OFF
Press power button
DVI-I input
terminal
INPUT-2
< >