Danby Designer DAR033A1WDD Manual Del Propietário página 5

OPERATING INSTRUCTIONS
TEMPERATURE SELECTION
The temperature can be adjusted by turning the
thermostat dial on the back of the appliance.
The thicker, darker part of the blue line is the coldest
setting.
The thinner, lighter part of the blue line is the
warmest setting.
The "O" position will turn off the cooling function.
Internal temperature of the appliance can vary
based on ambient temperature, the quantity of items
stored and how frequently the door is opened.
INTERIOR LIGHT
The interior light will turn on when the door of the
appliance is opened and will turn off when the door
is closed.
If the interior light burns out, it can be replaced with
a 15 watt bulb. Remove the screw securing the light
cover and then remove the light cover by pulling it
straight down. Replace the light bulb with a 15 watt
appliance bulb and replace the light cover.
Note: The functionality of the appliance is not
affected if the light has burned out.
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove the leveling leg. Remove the screws and
lower hinge from the right side of the appliance.
2. Remove the door from the cabinet.
3. Unscrew the upper hinge pin from the right side
of the worktop and screw it into the screw hole
on the left side of the worktop.
4. Remove the hinge hole cover from the top left
side of the door and install it in the hinge hole
on top right side of the door.
5. Install the door on the cabinet.
6. Install the lower hinge and leveling leg. Before
tightening the screws on the lower hinge, ensure
that the door is level with the cabinet and that
the rubber gasket is making a good seal all the
way around.
4