> Before Start
> Part Names
■ 3. LFE Level
Set the low-frequency effect (LFE) level for Dolby Digital series, DTS series, Multichannel
PCM, and DSD signals.
LFE Level
Select the low-frequency effect (LFE) level of each type of signal
from "0 dB (Default Value)" to "j ∞ dB". If the low-frequency
effect sound is too strong, select "j20 dB" or "j ∞ dB".
■ 4. Volume
Maximum Volume
Set the maximum value to avoid too high volume. Select "Off
(Default Value)" or a value between "30" and "49".
Headphone Level
Adjust the output level of the headphones. Select a value between
"j12 dB" and "i12 dB". (Default Value is "0 dB")
> Install
> Initial Setup
> Playback
Supplementary Information |
4. Source
■ 1. IntelliVolume
Adjust the volume level difference between the devices connected to the unit. Select the
input selector to configure.
IntelliVolume
Select a value between "j12 dB" and "i12 dB". Set a negative
value if the volume of the target device is larger than the others
and a positive value if smaller. To check the audio, start playback
of the connected device. (Default Value is "0 dB")
■ 2. Name Edit
Set an easy name to each input. The set name will be shown on the main unit display. Select
the input selector to configure.
Name Edit
1. Select a character or symbol with the cursors and press
ENTER.
Repeat it to input 10 or less characters.
"A/a": Switches between upper and lower cases. (Pressing
MODE on the remote controller also toggles between upper
and lower cases)
" ← " " → ": Moves the cursor to the arrow direction.
"
": Removes a character on the left of the cursor.
" ": Enters a space.
0 Pressing CLEAR on the remote controller will remove all
the input characters.
2. After inputting, select "OK" with the cursors and press
ENTER.
The input name will be saved.
0 To name a preset radio station, press TUNER on the remote controller, select FM/DAB
and select the preset number.
0 This cannot be set if the "NET", "USB" or "BLUETOOTH" input is selected.
Advanced Setup
| Others
E
N
35