Onkyo TX-L20DW Manual De Instrucciones página 8

> Before Start > Part Names
1. Connect the Speakers
Install
1
1
2
1/2˝
(12 mm)
3
a
3
b
a Speaker cable, b Subwoofer cable
> Install > Initial Setup
2
4
> Playback
Supplementary Information | Advanced Setup | Others
Refer to the illustration to connect the speaker system.
Twist the wires of the speaker cable tightly before inserting
into the SPEAKERS terminals. After inserting the cables,
tighten the terminals firmly by turning to the right. Make
correct connection between the unit's jacks and speaker's
jacks (+ to + and – to –) for each channel. If connection is
wrong, a bass sound may become poor due to reverse
phase.
To connect a powered subwoofer, use a subwoofer cable
and connect to the SUBWOOFER PRE OUT jack.
Make sure the exposed wires of the speaker cable do not
stick out of the speaker terminals when connecting. If the
exposed wires of the speaker cable touch the rear panel or
the + and – wires touch each other, the protection circuit will
be activated. ( P46)
Setup
Settings are required if a powered subwoofer is not
connected. Make settings after all connections are
complete. Press
Setup menu displayed set "2. Speaker" - "Configuration"-
"Subwoofer" to "No".
on the remote controller, and in the
E
N
7