Still Mode
You can pause the image shown on the TV screen.
Press [FREEZE] to pause the image shown on the TV
screen.
• The sound output will not be paused.
• If no signal is detected or protected signal is received
during still mode, the image remains paused and the
sound output will be muted.
• The still function will be released after 5 minutes.
To cancel still mode, press any button except
[y y (power)].
Switching Each Input Mode
You can easily switch with the remote control to the DTV (ATSC) and TV
(NTSC) or to access external devices when they are connected to the unit.
Press [SOURCE] or [CH
the input modes.
-
• Pressing [CH
] reverses the direction of the input
modes.
FREEZE
+
] repeatedly to cycle through
Source
TV
Video
Component
HDMI1
HDMI2
PC
DTV/TV channel
Video
Component
HDMI1
HDMI2
PC
Switching Audio Mode
This section describes how to switch the audio in the analog mode and how
to switch the audio language in the digital mode.
TV
Press [SAP/AUDIO] to display the currently selected
audio mode. While receiving an MTS broadcast,
press repeatedly to cycle through the available audio
channel.
When all audio are available
SAP
/ STEREO
SAP /
When stereo and monaural audio are available
MONO
/ STEREO
When SAP and monaural audio are available
SAP /
MONO
When only monaural audio is available
(cannot be switched)
STEREO
: Outputs stereo-audio
SAP
: Outputs second audio program
MONO
: Outputs mono-audio
DTV
1
Press [SAP/AUDIO] to display the currently selected
language and the number of available languages.
2
Press [SAP/AUDIO] repeatedly to cycle through the
available audio languages.
• Available languages differ depending on the
broadcast. "Other" is displayed when the audio
language cannot be acquired, or the acquired
languages are other than English, Spanish or French.
Note:
• [SAP/AUDIO] does not control external audio devices.
• The information display will automatically disappear in a
few seconds.
11
SAP
/ STEREO
SAP
/ MONO
STEREO
MONO /
STEREO
SAP
/ MONO
MONO
11.1
English 1/3
19
EN