Hart HGCS02 20V Manual Del Operador página 28

MAINTENANCE
TOP PLATE FILING ANGLE
See Figure 35.
 CORRECT 30° - File holders are marked with
guide marks to align file properly to produce
correct top plate angle.
 LESS THAN 30° - For Cross Cutting.
 MORE THAN 30° - Feathered Edge Dulls Quickly.
SIDE PLATE ANGLE
See Figure 36.
 CORRECT - 80° Produced automatically if cor-
rect diameter file is used in file holder.
 HOOK - "Grabs" and dulls quickly. Increases
potential of KICKBACK.
Results from using a file with diameter too small,
or file held too low.
 BACKWARD SLOPE - Needs too much feed
pressure, causes excessive wear to bar and
chain.
Results from using a file with diameter too large,
or file held too high.
DEPTH GAUGE CLEARANCE
See Figure 37 - 39.
 The depth gauge should be maintained at a
clearance of .025 in. Use a depth gauge tool
for checking the depth gauge clearances.
 Every time the chain is filed, check the depth
gauge clearance.
Use a flat file and a depth gauge jointer to lower
all gauges uniformly. Depth gauge jointers are
available in .020 in. to .035 in. Use a .025 in. depth
gauge jointer. After lowering each depth gauge,
restore original shape by rounding the front. Be
careful not to damage adjoining drive links with
the edge of the file.
Depth gauges must be adjusted with the flat file in
the same direction the adjoining cutter was filed
with the round file. Use care not to contact cutter
face with flat file when adjusting depth gauges.
FIG. 40
FIG. 41
MAINTAINING THE GUIDE BAR
See Figure 40.
CAUTION:
Make sure the chain has stopped and the bat-
tery pack has been removed before you do any
work on the saw to avoid accidental starting or
contact with the moving chain that may result
in injury.
Proper maintenance will maximize the useful life
of the guide bar.
Each day of use:
Clean the bar and check for wear and damage.
Feathering or burring of the bar rails is a normal
process of bar wear, but such faults should be
smoothed with a file as soon as they occur.
Each week of use:
 Reverse the guide bar on the saw to distribute
the wear.
 Lubricate the socket at the end of the guide bar
using a grease syringe in the lubricating hole.
 Turn the guide bar and check that the lubrication
holes and chain groove are free from impurities.
A bar with any of the following faults should be
replaced immediately:
28 – English
LUBRICATING HOLE