Publicidad
Idiomas disponibles
Idiomas disponibles
Display shows "noPr"�
Display shows "Ovht"�
Display is blank after
the cooker is plugged
in�
Rice is only half cooked
or is too hard�
Rice is too soft�
Sporadic beeping when
the multicooker is
cooking�
Occasional ticking
sound�
Working pressure was not
reached during the preheating
stage�
Overheating was sensed in the
inner pot�
No power connection or bad
power source�
Multicooker electrical fuse is
blown
Not enough water added�
Lid opened early�
Too much water added�
Multicooker is overheating
and has reduced the heating
temperature� It may not reach
the cooking pressure needed�
The heating element turning
on and off
Bottom of the inner pot on the
outside is wet�
If steam is leaking from the lid, see problem 3, 4, 5, and 6� If
steam is not leaking from the lid and you are cooking frozen
food, run the current program again�
Cancel the current program and see if the food at the bottom
of the pot is burned�
Examine the power cord to make sure the cord isn't damaged�
Check the outlet to make sure it is active�
Contact customer service�
Add more water according to the proper rice to water ratio�
Once cooking is finished leave the lid on for 5 minutes�
Adjust rice to water ratio according to rice directions�
Starch or other food has accumulated at the bottom of the
inner pot and have clogged heat from dispersing�
This is normal�
Make sure the inner pot is dry before cooking�
25
Publicidad
