Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE
Do not give a strong shock to the display panel or
break it. It may lead to a trouble.
13. Using the LED light
Pull the trigger switch to light up the LED light. The
LED light keeps on lighting while the trigger switch is
being pulled. The LED light goes out after releasing
the trigger switch. (Fig. 16).
LED Light
CAUTION
Do not look directly into the LED light. Such
actions could result in eye injury.
14. Using the hook (sold separately)
The hook is used to hang up the power tool to your
waist belt while working.
CAUTION
● When using the hook, hang up the power tool
fi rmly not to drop accidentally.
If the power tool is dropped, it may lead to an
accident.
● When carrying the power tool with hooked to
your waist belt, do not fi t any bit to the tip of
power tool. If the sharp bit such as drill is fi tted
to the power tool when carrying it with hooked to
your waist belt, you will be injured.
● Install securely the hook. Unless the hook is
securely installed, it may cause an injury while
using.
(1) Placing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fi x the hook fi rmly.
(Fig. 17)
Trigger
switch
Fig. 16
Hook
(2) Removing the hook.
Remove the screws fi xing the hook with Philips screw
driver. (Fig. 18)
OPERATIONAL CAUTIONS
Resting the unit after continuous work
After use for continuous tightening wood screw works,
rest the unit for 15 minutes or so when replacing the
battery. The temperature of the motor, switch, etc., will
rise if the work is started again immediately after battery
replacement, eventually resulting in burnout.
English
Groove
Screw
Fig. 17
Screw
Hook
Fig. 18
17
Publicidad
