Riello 566 M Instrucciones Para La Instalación, Uso Y Mantenimiento página 23

ELECTRICAL WIRING
~ 50/60Hz 230V
Main switch
general
KEY TO LAY-OUT
C – Motor capacitor
CN1 – Ionising probe connector
E – Ignition electrode
h1 – Hour counter
(230V - 0.1A max.)
MV – Fan motor
PA – Air pressure switch
3286
WARNING:

Do not swap neutral and phase over, follow the diagram shown
carefully and carry out a good earth connection.

The cross section of the wires must be at least 1 mm
otherwise by local standards and legislation).

The electrical wiring carried out by the installer must comply with the
rules in force in the country.
IMPORTANT
The burners have been approved for intermittent operation.
This means that they must stop once every twenty four hours
to permit the electrical control box to check its efficiency at
start up. Normally the boiler's limit thermostat (TL) ensures
the stopping of the burner. If this is not the case, it is neces-
sary to apply in series with the (TL) a timer switch that turns
off the burner at least once every twenty-four hours.
TESTING

Check the burner has stopped by opening thethermostats.

Check that the burner has locked out during operation by
opening the connector (CN1) inserted in the probe's red wire,
located outside the control box.
CONTROL BOX, (see fig. 2)
Black
To extract the control box from the burner it is necessary:
White

to disconnect all the connectors connected to it, the 7 pin
Blue
plug, and the earth wire (TB);

undo the screw (A) and pull out the control box in the direc-
tion of the arrow.
For the installation of the control box it is necessary:

to tighten up the screw (A) with a tightening torque of 1 -
1.2 Nm;

connect all the connectors that were previously connected.
D7057
PG – Minimum gas pressure
switch
RS – Remote reset conn.
SB – Lockout light
(230V - 0.5A max.)
SM – Single stage gate conn.
SO – Probe ionization
TB – Burner earth
5
Fig. 2
A
TL – Limit thermostat
TS – Safety thermostat
T6A – Fuse
V1 – Adjustment valve
VS – Safety valve
XP6 – 6 pin plug/socket
XP7 – 7 pin/plug socket
GB
2
. (Unless requested
E9322