GreenWorks ST24B02 Manual Del Operador página 8

EN
8.5 INSTALL THE BATTERY PACK
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.6 REMOVE THE BATTERY PACK
1. Push and hold the battery release button (15).
2. Remove the battery pack from the machine.
9 OPERATION
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1 START THE MACHINE
1. Push the lock-out button (2) and pull the trigger (1).
WARNING
IMPORTANT
WARNING
English
9.2 STOP THE MACHINE
1. Release the trigger to stop the machine.
9.3 ADJUST THE LENGTH OF THE
SHAFT
You can adjust the length of the shaft to operate the
machine easily.
15
1. Stop the machine.
2. Push the lock button (12) and move the lower shaft (7) to
the desired position.
3. Release the lock button.
9.4 CHANGE TO THE EDGING MODE
The machine can be used in combination with the edge
guide for edging sidewalks and walkways.
1. Stop the machine and flip down the edge guide from
stored position.
2. Push the lock button (12) and turn the lower shaft 90° or
180° until it engages.
8
2
1
NOTE
12
7
NOTE