Publicidad
Idiomas disponibles
Idiomas disponibles
3. Operations
EN
3.5 UPS Setting
Parameter 1
Parameter 2 Parameter 3
01: Output voltage setting
Interface
02: Frequency Converter enable/disable
Interface
03: Output frequency setting
Interface
40
PH 8010 | PH 8020 | PH 8030
Uninterruptable Power Supply
There are three parameters to set up the UPS.
Parameter 1: It's for program alternatives. Refer to the table.
Parameter 2 and parameter 3 are the setting options or values for
each program.
Setting
Parameter 3: Output voltage
For 200/208/220/230/240 VAC models, you may choose the following output voltage:
200: presents output voltage is 200Vac
208: presents output voltage is 208Vac
220: presents output voltage is 220Vac
230: presents output voltage is 230Vac (Default)
240: presents output voltage is 240Vac
Setting
Parameter 2 & 3: Enable or disable converter mode.
You may choose the following two options:
CF ENA: converter mode enable
CF DIS: converter mode disable (default)
Setting
Parameter 2 & 3: Output frequency setting.
You may set the initial frequency on battery mode:
BAT 50: present output frequency is 50Hz
BAT 60: present output frequency is 60Hz
If converter mode is enabled, you may choose the following output frequency:
CF 50: present output frequency is 50Hz
CF 60: present output frequency is 60Hz
Segurança e harmonia
ININTERRUPTA
Publicidad
