GYS PACK 660 Manual De Instrucciones página 15

Translation of the original instructions
GYSPACK 750
2
1
Product Battery
GYSPACK 750 6-SPB-25
To replace the battery :
• The booster must be disconnected form the power supply.
• First the back panel must be unscrewed (19 screws) and removed.
Once the back panel is removed, the battery front appears (cf illustration). Remove the positioning belt 1 .
•
The battery is connected to the GYSPACK at two points : at the - terminal 3 and at the + terminal 2 . To
•
remove the battery, remove the 2 screws that enable the connection between the battery and the GYSPACK at the
terminals + and -.
When putting a new battery, make sure to observe the polarities of both the battery and the
GYSPACK. Terminal - on the left, terminal + on the right (cf illustration). Put the 2 screws and
washers back, tighten the nuts (recommended torque wrench 4 N.m).
• Place the booster's backpanel screws back on.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
GYSPACK 660 / 750
Type Voltage (V)
Lead- acid battery 12
Dimensions
Capacity (Ah)
(cm)
28 20 x 14 x 16
EN
3
Battery ref
53140
15