Publicidad
9.
Connect the Supplies
Valve Inlet
Entrée de valve
Entrada de la válvula
Supply Tube
Tuyau d'alimentation
Tubo de suministro
Connect the supply tubes to the valve inlets and then to the shut-off valves. Left is
hot and right is cold.
Tighten all connections.
Raccordement des alimentations
Connecter les tuyaux d'alimentation aux entrées du robinet, puis aux robinets de
sectionnement. Chaud à gauche et froid à droite.
Serrer toutes les connexions.
Conecte los suministros
Conecte los tubos de suministro a las entradas de la válvula y luego a las llaves
de paso. El lado izquierdo corresponde al agua caliente, y el derecho, al agua fría.
Apriete todas las conexiones.
10.
Complete the Installation
Connect the tailpiece and P-trap (as needed).
Ensure that all connections are tight.
Open the drain.
Turn on the main water supply and check for leaks. Adjust as needed.
Turn the spray assembly down.
Open both hot and cold valves and run water for about a minute to remove
debris. Check for leaks.
Turn the faucet off.
Kohler Co.
Valve Inlet
Entrée de valve
Entrada de la válvula
Supply Tube
Tuyau d'alimentation
Tubo de suministro
Shut-off Valve
Arrêt d'alimentation
Llave de paso
15
1130187-2-A
Publicidad
