GYS MULTIPEARL 210-2 Manual De Instrucciones página 22

Translation of the original instructions
Selecting the metal thickness to weld
• Selecting the arc length
• Selecting the welding position
• Setting the management torch SPOT
and DELAY mode
SECONDARY MENU
Pre-Gas
Creep Speed
Burn back
Post - Gas
22
MULTIPEARL 210-2 / 210-4 XL / 211-4
Turn the upper knob to select the metal
thickness to weld.
Turn the lower knob to select the arc
length.
It gets longer (0 -> +9) or shorter (0 ->
-9) enabling to more or less penetrate
the metal. If you weld for the first time
we recommend to set the arc length to 0.
Keep button 1 pushed and turn both
knobs to select the welding position.
• Press button 3 repeatedly to select
Normal mode.
• Still pressing the button 3, turn the
upper knob to get to the SPOT mode.
Adjsutable between 0.5 to 5 sec.
In the same way turn the lower knob to
configure the DELAY mode. Adjustable
between 0 to 5 sec.
Hold down buttons 1 and 2 and use the upper
knob to select «PEG». Use the lower knob to
move the cursor to the setting. Use the upper
knob again to set the pre-gas from 0 ms to
1000 ms (in 100 ms steps)
The default setting is 0 ms.
Hold down buttons 1 and 2 and use the upper
knob to select «CSP». Use the lower knob to
place the cursor on the setting. Use the upper
knob again to adjust the creep speed from 50%
to 100% (in 10% steps). If the setpoint is 4m/
min and the CSP is set to 50%, then the Creep
Speed will be 2m/min. The default setting is
50%.
Hold down buttons 1 and 2 and use the upper
knob to select «BUB». Use the lower knob to
move the cursor to the setting. Use the upper
knob again to adjust the Burn Back from 0 ms
to 20 ms (in 1 ms steps). The
The default setting is 10 ms.
Hold down buttons 1 and 2 and use the upper
knob to select «POG». Use the lower knob to
move the cursor to the setting. Use the upper
knob again to adjust the Post Gas from 0 ms to
1 000 ms (in 100 ms steps).
The default setting is 300 ms.
+
+
+
+
+
+
EN