GYS MULTIPEARL 210-2 Manual De Instrucciones página 25

Translation of the original instructions
• Welding current adjustment
• Downslope adjustment
• Post gas adjustment
TIG EASY (VALVE TORCH)
• Entering in TIG EASY mode (valve
torch)
• Welding current adjustment
TIG LIFT WELDING
DC TIG welding requires the use of gas (Argon). Connecting a valve torch will allow to manually adjust the supply of gas and connec-
ting a EURO torch will also offer capability to adjust downslope and post gas settings.
For TIG welding please follow the stages below :
TIG Lift Pro welding with a Euro torch
• See connection page 4.
• Connect the gas hose to the back of the machine and to the
gas bottle regulator.
• Adjust the gas flow on the gas bottle regulator.
• To strike an arc touch the piece of metal to weld and press the
torch trigger.
• Downslope and Post-gas start automatically once the trigger is
released. They can be adjusted on the device.
MULTIPEARL 210-2 / 210-4 XL / 211-4
Use the upper knob.
Use the lower knob.
Keep button 3 pushed and at the same
time use the upper knob to adjust the
Post Gas.
Keep button 2 pushed and at the same
time turn the upper knob until "TIG
EASY" is displayed.
Use the upper knob.
+
+
TIG Lift EASY welding with a Valve torch
• See connection page 4.
• Connect the gas hose from the torch to the gas bottle
regulator.
• Adjust the gas flow on the gas bottle regulator and then open
the torch valve.
• Striking :
Touch the piece of metal to
weld with the electrode
• At the end of the weld :
Lift the electrode to
between 2 to 5 mm from
the metal.
Only stop the gas once the Tungsten electrode has cooled
down.
EN
25