CASO DESIGN HB 2400 Pro XL Manual Del Usuario página 30

15.1 Safety information
Please observe the safety instructions, before cleaning your device
► The blades are really sharp. Handle them with care.
► Do not immerse the main device in water.
15.2 Cleaning
1. Unplug the appliance.
Remove the blades and clean them under running water with a mild detergent. Dry them
thoroughly and store the blades in the storage section in the base.
Wipe the main appliance with the blender with a damp cloth and then dry it thoroughly.
► For quick cleaning, pour warm water with some dish soop in a jar, insert the blender bar
and let the appliance operate for approx. 10 seconds.
16 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
16.1 Security advices
► Repairs of electrical appliances must be carried out by qualified personnel who are
trained by the manufacturer.
► Repairs performed by untrained persons may result in considerable hazards for the user
and damage the machine.
16.2 Troubleshooting
Fault
The device does
not start.
The unit has shut
down.
► If above mentioned steps don't solve the problem, please contact your customer
service.
► Please clean the device before sending it to customer service.
Attention
Please note
Attention
To Rectify
Please check whether the power plug is properly plugged.
The overheat protection was activated. Pull out power supply plug
and wait for the motor to cool (about 20 to 30 minutes), then use
again.
Please note
30