Cameo CLF4T Manual De Usuario página 6

---------------- Menu ----------------

DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
ZOOM
8
On either side of the cabinet is a calibration control to manually adjust the beam angle. The two controls are mechanically linked and are
directly opposite each other on the housing. Turn the calibration control to adjust the beam angle of the spotlight continuously. A rack and
pinion system moves the zoom tube with the Fresnel lens in and out of the housing. The further the zoom tube protrudes from the housing,
the smaller the beam angle. A stop mechanism prevents the tube from becoming detached from the housing.
OPERATION
TIPS
• As soon as the spotlight is correctly is connected to the power supply, the following will be displayed in succession: "Welcome to Cameo",
the model name and the software version. After this process, the lamp is ready for operation and starts in the previously enabled mode.
• If one of the DMX modes or slave mode is enabled and there is no control signal at the DMX input, the characters in the display will start
to flash.
• If no input is made within approximately 30 seconds, the currently activated mode is automatically shown in the display (main display).
MAIN DISPLAY
The main display shows the currently activated mode (in the example DMX mode with DMX start address 001).
DMX Address
001
SETTING DMX START ADDRESS (DMX ADDRESS)
Press the encoder to access the main menu. Rotate the encoder to select the menu item "DMX Address" (left arrow) and confirm by pushing the
encoder. You can now configure the DMX start address as required by rotating the encoder (the highest value depends on the selected DMX mode).
Confirm the entry by pushing the encoder. Select the arrow symbol at the top of the menu for "back" and push the encoder to return to the main
display. The main display is activated automatically if no input is made within approximately 30 seconds. DMX mode is automatically activated
when setting the DMX start address.
---------------- Menu ----------------

DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
6
001
DMX Address
–
5xx
001