HAMPTON BAY 102 545 257 Manual De Instrucciones página 6

ASSEMBLY AND INSTALLATION INSTRUCTIONS:
1. Shut down the main electrical supply from the fuse box or circuit breaker in your house or building.
2. Fasten the mounting strip onto the outlet box using 2 outlet box screws.
3. Thread the threaded tube into center hole of mounting strip about 4 complete turns. Lock in place with
lock washer and hex nut. This threaded tube should extend long enough to protrude through the canopy
when it is mounted. (Adjust as needed)
4. Guide fixture wire and bare copper grounding wire through the tube. Make sure the tube cover the bushing
of the fixture body, then use two set screws to secure the arms onto each holder of the fixture body by
Phillips screw driver (not provided). (See diagram illustration)
5. Guide fixture wire and bare copper grounding through the loop and tighten the loop onto upper nipple
joint.
6. To adjust the chain to the desired length, spread the end link of the chain and remove unnecessary links.
Two people are suggested for this step. One to hold the chain, and one to separate the links. Use a pair of
pliers and a screwdriver. Wrap a soft cloth around pliers to protect the finish of the chain.
7. Tighten the screw collar loop to the threaded tube on the mounting strip. Open one quick link, hook the end
of chain to the loop of the fixture body and close the quick link. Open other quick link, hook it to the other
end of the chain. Place the ring and canopy over the chain on the fixture, then hook the whole fixture to the
screw collar loop on the ceiling and close the quick link.
8. Weave the fixture wires and bare copper ground wire up through the chain links, ring, canopy, screw
collar loop and the threaded tube in the mounting strip and then into outlet box. Position both the supply
wires and the fixture wires outside of the outlet box to facilitate connection.
9. Connect the wire from the fixture to the power supply wire from outlet box. Cover with wire connectors.
A. Twist together glossy / live wire from the fixture with black wire from outlet box. Cover with wire
connector.
B. Twist together rough / neutral wire from the fixture with white wire from outlet box. Cover with wire
connector.
C. The bare copper grounding wire from the fixture must loop one turn under the head of green screw
on mounting strip before it is connected to the grounding conductor of the supply circuit.
Note: The Glossy/Live wire has the text printed on it; the Rough/Neutral wire has the ridge on it.
10. Carefully position all wiring inside outlet box.
11. Place the canopy all the way to the ceiling and tighten the ring onto the screw collar loop until the canopy
is firmly held against the ceiling.
12. Unscrew the socket rings from sockets. Set shades onto each socket and secure with socket rings.
13. Install the bulbs (not included). Use 60-watt Maximum standard type A bulbs or MAX 13W UL
LISTED CFL bulb.
14. Turn on the electrical power in your house or building to activate the kitchen island pendant.
6