Silvercrest SSTME 600 B1 Instrucciones De Uso página 16

NOTE
►
Cleaning
►
►
►
CAUTION! PROPERTY DAMAGE!
►
Cleaning the blender
To prevent injuring yourself on the cutting blades 4, clean the blender 3 only
■
with a long-handled washing-up brush.
Clean the measuring cap 1 and the lid 2 in mild soap solution. Ensure that
■
the rubber seal 9 is correctly fitted before using the lid 2 again.
NOTE
■ If you clean the appliance directly after use, you can usually achieve
sufficiently hygienic cleaning results by using the following alternatives:
Fill the blender 3 with 750 ml of water and add a couple of drops of mild
washing up liquid. Close the lid 2 and fit the blender 3 onto the motor
block 6. Insert the mains plug into the socket and activate the pulse function
a few times so that the cutting blades 4 plough through the water at maximum
speed. Afterwards, rinse the blender 3 with plenty of clean water to remove
any washing up liquid residues.
SSTME 600 B1
In cases of lactose intolerance, we recommend you use a lactose-free milk.
Keep in mind, however, that lactose-free milk is a little sweeter.
DANGER! ELECTRIC SHOCK!
Before starting to clean the blender and its components:
Ensure that the motor is switched off and the power plug removed from the
socket.
Do not immerse the motor block 6 in water or other liquids. This could
result in you receiving a fatal electric shock and cause damage to the
appliance.
Never open the housing of the appliance. Otherwise, there is a risk of a
fatal electric shock.
WARNING! RISK OF INJURY!
Never insert your hand or fingers into the blender 3, especially while it is
in use. The cutting blades 4 are extremely sharp!
Do not use solvents or abrasive cleaners on the plastic surfaces, they could
be damaged by them.
You can also clean the lid 2, the measuring cap 1 and the
blender 3 with the cutting blade 4 in your dishwasher.
If possible, place all the parts in the upper basket of the dishwasher
and make sure that they are not jammed in place.
GB │ IE │
13 ■