Milwaukee 2607-20 Manual Del Operador página 72

SPECIFICATIONS
Cat. No. ..................................................... 2680-20
Volts .............................................................. 18 DC
Battery Type .................................................M18™
Charger Type ................................................M18™
Rated RPM ...................................................10,000
Spindle Thread Size .................................... 5/8"-11
Max Capacity ....................................... 4-1/2" x 1/4"
Recommended Ambient
Operating Temperature ......................0°F to 125°F
SYMBOLOGY
Volts
Direct Current
Rated Revolutions per Minute (RPM)
UL Listing for Canada and U.S.
C US
FUNCTIONAL DESCRIPTION
1
2
1. Side handle
2. Spindle lock
3. Side handle sockets
4. Handle
5. Paddle switch
4
3
5
7
6
8
6. Switch lock-off
9
7. Guard
8. Guard lock lever
9. Accessory
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
To reduce the risk of injury when
WARNING
grinding, always use properly in-
stalled guards.
Removing/Installing/Adjusting the Guard
This tool is shipped with a guard. A guard must be
used when using the tool as a grinder. The guard may
be removed when using tool as a sander.
1. To remove the guard, remove the battery pack
and remove any accessories from spindle.
2. Press in the guard lock lever and rotate the guard
to line up the tabs on the grinder with the slots in
the guard.
3. Press in the lock lever and lift the guard straight
up and away from the tool.
Tab
slots
4. To install the guard, remove the battery pack and
remove any accessories from the spindle.
5. Line up the tabs on the grinder with the slots in
the guard.
6. Press in the guard lock lever and press the guard
onto the tool.
7. To adjust the guard, press in the guard lock lever
and rotate the guard to one of five detent slots.
WARNING! Always adjust the guard to provide the
operator with maximum protection while operating.
5
Detent
slots