Parkside PDEXS 150 C2 Traduccion Del Manual De Instrucciones Originale página 52

Operation
Switching on and off
Switching on:
♦ First press the locking mechanism forwards and
then the trigger
Switching off:
♦ Let go of the trigger
♦ When you have finished working, disconnect
the appliance from the compressed air source.
Regulation of vibration output
■
Use the speed controller
flow and thus the vibration output (also during
operation).
■
The ideal speed depends on the material being
worked and can be determined through practical
tests.
Use the pressure reducer to set the correct working
pressure.
Sanding
♦ Switch on the compressed air source and allow
it to run until the maximum tank pressure has
been reached.
♦ Use the pressure reducer on the compressed
air source to set the optimum working pressure.
Note that the maximum working pressure may
not be exceeded. An excessive working pres-
sure does not mean increased output; it merely
increases the air consumption and accelerates
appliance wear. Always comply with the techni-
cal information.
♦ Switch on the compressed air-powered random
orbital sander.
♦ Allow the device to reach the required speed
and adjust as necessary.
♦ Guide the compressed air-powered random
orbital sander parallel onto the workpiece.
♦ Move the appliance parallel and in flat circles
or alternatively lengthwise and across the sur-
face. Use the housing
the appliance in the desired direction.
PDEXS 150 C2
to switch the appliance on.
.
to control the air-
as a handle to guide
♦ Do not press the compressed air-powered ran-
dom orbital sander down. Pressing down hard
does not increase the working efficiency!
♦ When you have finished working, let go of the
trigger to switch off the appliance.
♦ When you have finished working, disconnect
the appliance from the compressed air source.
CAUTION!
► Sanding creates dust. Always wear protective
gloves, a suitable mask and clean the sand-
paper and workpiece at regular intervals with
a vacuum cleaner or compressed air.
► Suitable safety precautions must be taken
depending on the size and nature of the
workpiece. Use suitable clamping devices to
prevent the workpiece from slipping.
► In the event of an interruption to the air sup-
ply, release the trigger
Working procedures
The most important thing to remember when sand-
ing is to use successively finer grained paper.
With a coarse grain, the surface will not become
smooth, but rather rougher. If the grain is too fine,
you will hardly achieve any noticeable result.
The material removal rate is determined by the
speed and grain size of the sandpaper.
The sandpaper used should be appropriate to the
substance being worked and the amount of mate-
rial to be removed.
CAUTION!
► Ensure that the appliance is disconnected
from the compressed air source before you fit
or remove a sandpaper disc
immediately.
.
GB │ MT │
49 ■