Parkside PDEXS 150 C2 Traduccion Del Manual De Instrucciones Originale página 53

Material
Paintwork: rubbing down
removing
scratches
removing rust
Wood: softwood
hardwood
plywood
Metal: aluminium
steel
Maintenance and cleaning
WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply.
CAUTION!
► Before maintenance, clean off any hazardous
substances that may (due to working pro-
cesses) have accumulated on the appliance.
Avoid all skin contact with these substances.
If the skin comes into contact with hazardous
dusts, this can lead to severe dermatitis. If
dust is produced or swirled up during mainte-
nance, it can be inhaled.
NOTE
To ensure correct functioning and long-term
durability of the sander, pay attention to the
following points:
■ Sufficient and continuously intact oil lubrication
is highly important for optimum functioning.
■ Check the speed and vibration levels after each
use.
■ Check the idle speed regularly and after any
maintenance is performed:
use a rev counter and perform the measurement
without any clamped tools. The idle speed may
not be exceeded under any circumstances at a
residual pressure of 6.3 bar.
│ GB │ MT
■ 50
■
Grain
180
120
■
40
60–80
■
60
■
240
■
80
60
Troubleshooting
Fault
Speed too
slow, air
escapes from
the outlet.
Appli-
ance does
not move;
compressed
air escapes
completely
through the
outlet.
If the appliance is exhibiting excessive vibration
levels, the cause of the vibrations must be identi-
fied and repaired.
Use only the genuine replacement parts recom-
mended by the manufacturer, otherwise you
could put users at danger. In doubt, contact the
Service Centre.
Check the sanding disc
Clean the appliance with a soft, dry cloth only.
Never use sharp or scratchy cleaning agents
under any circumstances.
Possible
cause
Motor parts
jamming due
to dirt.
Pressure sup-
ply too low.
Motor is
jammed due
to material
build-up.
regularly for damage.
Remedy
Check the
pressure sup-
ply filter for
contamination.
Check the
pressure sup-
ply filter for
contamination.
Lubricate
appliance as
described in
the instruc-
tions.
If necessary,
repeat the
steps outlined
above.
Lubricate
appliance as
described in
the instruc-
tions.
PDEXS 150 C2