Publicidad
Idiomas disponibles
Idiomas disponibles
General safety advice for electrical power tools / Before use / Preparing for use
Note: TPI = teeth per inch / (i.e. per 2.54 cm)
blade (wood)
:
11
Dimensions: 152 x 1.25 mm, 6 TPI
Most suitable for: Sawing construction timber,
chipboard, processed wood boards, plywood.
Also suitable for plunge cuts.
bi-metal saw blade
Dimensions: 156 mm, 18 TPI
Most suitable for: Sawing sheets, profiles and tubes
– flexible and fracture resistant.
before use
Q
Mounting / replacing
Q
saw blades
Pull the mains plug out of the
mains socket before you carry out any task on the de-
vice. Failure to observe this advice may lead to injury.
j
T urn the quick-release chuck
the turned position.
j
P ress the selected saw blade up to the stop
into the quick-release chuck
should engage.
j
R elease the quick-release chuck
must then return to its original position. The saw
blade is now locked in place.
Rotating the hand grip
Q
DANGER oF INjURy! Pull
the mains plug out of the socket before you carry
out any task on the device, The hand grip
be rotated by 90° to the right or left. This allows
the on / oFF switch
3
comfortable position for any working conditions.
j
P ress the unlocking button
hand grip
to the right or left.
4
j
M ake sure the hand grip
Adjusting the shoe
Q
DANGER oF INjURy! Pull
the mains plug out of the socket before you carry
out any task on the device.
40 GB/MT
:
12
and hold it in
7
. The saw blade
7
. The chuck
7
can
4
to be brought into the most
and rotate the
10
engages.
4
j
A djust the shoe
5
j
T o do this release the shoe adjustment lever
and place the shoe
j
L ock the shoe in this position by pulling the
shoe adjustment lever
Setting the blade speed
Q
The desired blade oscillation speed can be prese-
lected by using the setting wheel
oscillation speed, + = highest oscillation speed).
The blade speed can also be selected whilst you
are using the device.
Preparing for use
Q
Switching on and off
Q
When operating the device you can select between
intermittent or continuous operation mode.
To switch on intermittent operation mode:
j
P ress the on / oFF switch
To switch off intermittent operation mode:
j
R elease the on / oFF switch
To switch on continuous operation mode:
j
P ress the on / oFF switch
pressed position with the lock button
To switch off continuous operation mode:
j
P ress the on / oFF switch
again.
Guiding the sabre saw
Q
safely and accurately
The shoe
pivots to adjust to the workpiece and
5
provides safe support to the device. It must always
lie against the workpiece when the device is in use.
to suit the cutting depth.
in appropriate position.
5
tight.
8
(– = lowest
1
.
3
.
3
and fix it in the
3
.
2
and release it
3
8
Publicidad
