Rewa Mirabello MIR 30 Instrucciones Y Garantía página 32

VII.b CLEANING THE ROTOR
WARNING: Disconnect all electrical devices of the aquarium from the power grid.
To clean the rotor turbine pump perform the following steps:
1) Remove NEWA Mirafilter cover and disconnect the ventilation tube from the pump.
2) Spin the pump outlet reflector to the inside part of the filter (Fig. 26).
3) Separate the pump from the case and put it aside (fig. 28).
4) Move the magnetic rotor close to the turbine by opening and disconnecting the chamber from the turbine (Fig. 29).
5) Remove the magnetic rotor along with the turbine chamber; clean them with a brush and plain water. If they are covered with
lime, leave them in diluted acetic acid for 15-20 minutes before brushing. Rinse carefully.
WARNING: Do not use acid or solutions different from diluted acetic acid as they can be toxic for fish.
VII.c MAINTENANCE OF THE VENTILATION SYSTEM
EN
Follow these simple instructions to clean the ventilation system of the pump:
A) Implement paragraphs 1-5 relating to cleaning the rotor turbine.
В) Use a plastic wire packed with service details and insert it into the hole of the motor shaft (Fig. 30).
С) In the event of any difficulties make Mirabello efforts. If this fails, try to gently insert the steel wire of suitable diameter.
D) If this action has led to the failure, it is necessary to put the pump housing into the diluted acetic acid and then try to clean it
with a wire. To do so, it is necessary to release the cord pump and to remove the locking mechanisms (Fig. 31).
VII.d REPLACEMENT OF HEATER AND PUMP FILTER
WARNING: It is recommended to remove the power cable from the heater and other appliances before you start the procedure.
To replace the NEWA Therm eco heater, wait at least 15 minutes before removing it from the water.
1) Aprire il coperchio e togliere l'accessorio da sostituire staccando il cavo dagli speciali ferma-cavo posti nella parte inferiore
del coperchio.
2) Remove the replacement part by disconnecting the case from the special locking mechanisms on a cap or on the internal unit
of the aquarium, or on the upper part of it.
VII.e LED LIGHT REPLACEMENT WITH TOUCH CONTROL
1. Unplug the power cord from the power outlet and disconnect the power supply from the power cord by using the power supply
connector (fig. 32).
2. While holding the aquarium lid open firmly with one hand, remove the cable passage protection cover by pulling it toward
yourself (fig. 8).
3. Extract the plug and connector from the specific opening provided on the lid.
4. Unscrew the screws on the ceiling light and remove it.
5. Install the new ceiling light and repeat the above steps in reverse order.
32