HAMPTON BAY HB-4133-OR Guía De Uso Y Cuidado página 10

Care and Cleaning
□
To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
□
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
□
Do not spray the light fixture with a hose or power washer.
Troubleshooting
Problem
The light will not come on.
The light comes on during
the day.
The light comes on for no
apparent reason.
Possible Cause
□
The light switch is turned off.
□
The fuse is blown or the circuit
breaker is turned off.
□
Bulbs are loose or burned out.
□
Daylight turn-off (photocell) is in
effect.
□
The circuit wiring is incorrect (if this
is a new installation).
□
The outside air temperature is close
to the same as a person's body
heat.
□
The motion sensor may be installed
in a relatively dark location.
□
The "ON-TIME" switch is in the
"TEST" position.
□
The motion sensor may be sensing
small animals or automobile traffic.
□
The "Sensitivity" setting is set too
high.
□
The outside temperature is much
warmer or cooler than a person's
body heat (summer or winter).
□
The light fixture is wired through a
dimmer or timer.
10
Solution
□
Turn the light switch on.
□
Replace the fuse or turn the
circuit breaker on.
□
Inspect bulbs and replace if
needed.
□
Recheck after dark.
□
Verify the wiring is correct.
□
Increase the "Sensitivity"
setting.
□
The light fixture is operating
normally under these
circumstances.
□
Set the "ON-TIME" switch to the
1, 5, or 10 minute setting.
□
Decrease the "Sensitivity"
setting or use the lens shield to
reduce the coverage area.
□
Decrease the "Sensitivity"
setting.
□
Decrease the "Sensitivity"
setting.
□
Do not use a dimmer or timer to
control the light fixture. Replace
the dimmer or timer with a
standard on/off wall switch.