Turning Off The Engine; Checking The Clutch - Garland MONTANA 110J-V16 Manual De Instrucciones

6.4.2 STARTING WITH A WARM ENGINE
In the event that the machine is hot:
1. Set the switch to position (I).
2. Make sure the choke/air level is stuck RUN.
3. Place the machine on the ground on a horizontal
and stable location.
4. Firmly hold the front handle with your left hand and
hold the rear of the saw with your right knee
5. Pull the Start cord until the engine starts.
If after a few attempts the machine does not start
follow the steps of starting with a cold engine.
6.4.3. STARTING THE CHAINSAW IN THE TREE
Only for starting in the tree with an already hot
machine. The operator shall:
1. Press the brake chain (brake on).
2. Turn the switch to position (I).
3. Place chainsaw with the chain to the right or left of
the body.
A. If the chainsaw is positioned on the left side:
I. Hold the chainsaw with the left hand on the
front handle.
II. Hold the starter with the right hand handle.
III. Sharply push the chainsaw away from the
body while the right hand holding the Starter
handle.
V. If after several attempts the chainsaw will not
start, hand the chainsaw to the operator on the
ground for checking.
B. If the chainsaw is positioned on the right side:
I. Hold the chainsaw with the hand right over the
front handle.
II. Hold the starter rope with the left hand
III. Sharply push the chainsaw away from the
body while the left hand holds the starter
handle.
IV. If after several attempts the chainsaw will not
start, give the chainsaw to the operator on the
ground for checking.

6.4.4 TURNING OFF THE ENGINE

Stop using speed and allow the engine to remain idle
for half a minute.
Stop the engine by turning the switch to the "O"
position.
6.5. CHECKING POINTS AFTER START UP
It is important to pay attention to the possible
individual parts and the temperature of the machine.
If you detect any anomaly in the machine immediately
stop and check it carefully. In case of any malfunction
or problem take the machine for a service repair.
Under no condition should you continue to use the
machine if the operation does not seem appropriate.
Do not use the machine if it is damaged or
improperly adjusted.

6.5.1. CHECKING THE CLUTCH

After having booted the machine, the chain should not
move if the engine is at idle. If the chain rotates idle
the engine idle will be necessary to adjust, so turn the
carburetor "T" screw until the chain stops.
If the motor is stalled before the chain stops, take
your chainsaw to service technician for adjustment.
The adjustment of the "H" and "L" screws
should only be performed by the authorized service
technician.
47/160
English