Publicidad
Idiomas disponibles
Idiomas disponibles
English
CAUTION: When changing to a new wheel, readjust
depth stop to original position to prevent cutting into
supporting surface.
Trigger Switch (Fig. A)
To start the tool, depress the trigger switch
tool off, release the trigger switch. Keep hands and material
from wheel until it has coasted to a stop. To prevent
unauthorized use of tool, install a standard padlock (not
included) into the padlock hole
Material Clamping and Supporting (Fig. B)
•
Angles are best clamped and cut with both legs resting
against base.
•
A spacer block slightly narrower than the work piece
can be used to increase wheel utilization.
•
Long workpieces must be supported by a block so it will
be level with top of base (Fig. B). The cut off end should
be free to fall downward to avoid wheel binding.
Fig. B
Block
Vise Operation (Fig. A)
The vise
has a quick-travel feature. To release the
6
vise when it is clamped tightly, turn the crank
counterclockwise one or two times to remove clamping
pressure. Lift vise lever
9
up. Pull crank assembly out as far
as desired. Vise may be pushed forward into work without
cranking. Lower vise lever then tighten vise
using crank.
Fence Operation (Fig. A, C)
WARNING: Turn off and unplug the tool before
making any adjustments or removing or
installing attachments or accessories. Be sure the
trigger switch is in the OFF position.
The fence
5
can be adjusted two ways: to change desired
cutting angle and to change spacing between the fence
and vise.
6
13
. To turn the
located in the trigger.
15
Cut-off end
8
on work by
6
To Change Spacing Between the Fence
and Vise
Using the 5/16" (8 mm) hex wrench
and remove the two fence bolts
to desired locations. Insert both fence bolts in provided
locations. Securely tighten both fence bolts before use.
Fig. C
5
16
To Change the Desired Cutting Angle
(Fig. A, D)
Use the 5/16" hex wrench
7
remove) the two fence bolts
indicator line with the slot line in the base
tighten both fence bolts before use. For more accurate
square cuts, disconnect the power supply, loosen the two
fence bolts, push arm down until wheel extends into base.
Place a square against the wheel and adjust fence against
the square. Securely tighten both fence bolts before use.
When making a miter cut, the vise
securely, depending on the thickness of the workpiece and
the miter angle. Other aids (such as spring, bar or C-clamps)
will be necessary to secure the work piece to the fence
when making these cuts.
Fig. D
16
Removal and Installation of Wheels
(Fig. A, E, F)
WARNING: Turn off and unplug the tool before
making any adjustments or removing or
installing attachments or accessories. Be sure the
7
provided, loosen
16
. Adjust the fence
5
provided to loosen (do not
16
. Align the desired angle
4
. Securely
6
may not clamp
Publicidad
