Publicidad
Idiomas disponibles
Idiomas disponibles
Finishing the Fan
Installation
STANDARD CEILING MOUNTING
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING PLATE MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
1. Align the locking slots of the ceiling
canopy with the two screws in the
mounting plate. Push up to engage the
slots and turn clockwise to lock in place.
Immediately tighten the two mounting
screws firmly.
2. Install the remaining two mounting screws
into the holes in the canopy and tighten
firmly.
3. Install the decorative canopy ring by
aligning the ring's slots with the screws in
the canopy. Rotate the ring clockwise to
lock in place.
4. You may now proceed to attaching the
fan blades.
7.
Attaching the Fan
Blades
1. Insert the blade through the slot
cut-off in the center flywheel, align
the three screw holes in the blade
with the screw holes in the flywheel
and secure with the screws provided.
(Figure 13)
2. Repeat for the remaining blades.
Figure 12
Motor Assembly
Blade
Screws
Figure 13
Publicidad
