Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the Light Kit
Pan/Light Kit Fitter
Assembly
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing the light kit.
1. Loosen but do not remove two of three
mounting screws from the fan motor
assembly; Remove one mounting screw.
(Figure 15)
2. Push the light kit pan up to the fan motor
assembly so that the two loosened screw
heads fit into the keyhole slots. Turn the
light kit pan clockwise, tightened the
screws. Re-install the screw that was
removed in step 1 and tighten firmly.
(Figure 15)
3. Remove one screw from the light kit pan
and loosen, but do not remove the other
two screws. Connect the wires from the
light kit fitter assembly to the wires from
the fan motor assembly by connecting the
molded adaptor plugs together. Carefully
tuck all wires and splices into the switch
cap. (Figure 16)
9.
4. Push the light kit fitter assembly up so
that the two loosened screw heads fit into
the keyhole slots. Turn the light kit fitter
assembly clockwise, tighten the screws.
Re-install the screw that was removed in
step 3 and tighten firmly. (Figure 16)
5. Place the shade into the light kit pan,
aligning the three flat areas on the top of
the shade with the three raised dimples in
the light kit pan. Turn the shade clockwise
until it stops. Make sure to twist the lens
in completely. Exert enough force to get
over the first bump and twist completely in.
(Figure 17)
PERIODICALLY CHECK THE GLASS SHADE IS
SEATED FULLY CLOCKWISE IN THE LIGHT KIT
PAN ASSEMBLY.
Motor
Assembly
Screws
Blue
Light Kit Fitter
Black
Assembly
Raised
Dimples
Light Kit
Pan
Figure 15
Light Kit
White
Pan
Screws
Figure 16
Flat
Area
Shade
Figure 17
Publicidad
