Troy-Bilt TB272V Manual Del Usuario página 9

Idiomas disponibles

Installing the Vacuum Bag

1. Set the unit on a flat, level surface.

2. Align the bumps on the vacuum elbow tube with the slots on the

blower outlet (Fig. 8). The flared end of the vacuum elbow tube

should point to the right.

3. Insert the vacuum elbow tube into the blower outlet (Fig. 8).

4. Twist the vacuum elbow tube clockwise until it locks into place

(Fig. 8).

5. Insert the flared end of the vacuum elbow tube approximately 4

inches (10 cm) into the vacuum bag (Fig. 9).

6. Pull the cinch strap to tighten the vacuum bag around the

vacuum elbow tube (Fig. 9).

NOTE: The cinch strap should be tight enough to prevent the

vacuum elbow tube from slipping out of the vacuum bag, but

loose enough for the vacuum bag to have limited movement

along the vacuum elbow tube.

Upper

Vacuum Tube

Blower Outlet

Vacuum

Elbow Tube

Vacuum

Elbow Tube

Cinch Buckle

Dots

Arrows

Vacuum Tube

Fig. 7

Fig. 8

Cinch Strap

4 inches

(10 cm)

Fig. 9

Lower

Slots

Bumps

Vacuum Bag