Garland GRASS 1065 ZSH Manual De Instrucciones página 44

English
machine. If you detect any anomaly in the machine
immediately stop and check it carefully.
In case of any malfunction or problem take the
machine to a service technician to be repaired.
Under no circumstances must you continue to use the
machine if the operation does not seem appropriate.
Do not use the machine if it is damaged or improperly
adjusted.
7. USING THE MACHINE
Use this machine only for the designated
purposes. Using this chainsaw for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
Do not start the machine in a room or
enclosure. The exhaust gases and fuel and
oil vapors contain carbon monoxide and
harmful chemicals. In case of a concentration of gases
produced by poor ventilation, remove all that impedes
the flow of clean air to improve ventilation from the
work area and not return to work in the area unless
you have properly ventilated area and have clear that
ventilation is sufficient so that does not happen this
concentration again.
Work only in daylight or good artificial light. Do not use
this machine at night, with fog or with a low visibility
which do not allow you to clearly see the working
area.
Whenever possible, avoid using this machine when
the ground is wet. Pay special attention if you use this
machine when it is raining or after it has rained, as
the ground will be slippery and you could slip and fall.
Do not use this machine on slopes
DANGER
DO NOT USE MOWER WITHOUT ENTIRE
greater than 15°. Cutting on hilly
GRASS CATCHER OR DEFLECTOR IN PLACE
KEEP HANDS and FEET AWAY
areas can be dangerous.
Be alert when you walk on slopes or wet grass. Slopes
always cut horizontally, not cut bottom up or top down.
Be especially careful when changing direction on a
slope.
Never cut with the mower in reverse or by pulling it.
Be alert when you back up or pull the mower towards
you.
Do not tilt the machine with the engine running except
in the special case that you have to start cutting an
area with tall grass. This is the only case in which you
can raise the front wheels slightly to facilitate entry of
the mower to the work area. Stop the lawnmower's
engine if you tilt it to cross surfaces other than grass
and when transporting the lawnmower to and from the
area to be cut.
Do not go near the machine's cutting tool when it is
running. Danger! Risk of finger amputation.
Keep hands and feet away from the blades.
Do not solely rely on the security features of this
machine.
It is necessary to pay attention to the possible
loosening or overheating of the parts of the machine.
If you detect any anomaly immediately stop the
machine and check it carefully.
In case of mechanical failure take the machine to the
technical service for repair. You should not continue
working if you notice that the operation is not correct.
44/172