Descargar Imprimir esta página

GreenWorks MO24B00 Manual Del Operador página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Put in the safety key.
2. Push and hold the start button (2).
3. While you hold the start button, pull the handle switch (1)
in the direction of the handle bar.
4. Release the start button to start the machine.
8.2
STOP THE MACHINE
1. Release the handle switch to stop the machine.
WARNING
Wait until the blade fully stops before you start the machine
again. Do not quickly turn the machine off and on.
WARNING
Always remove the safety key and battery pack after you
complete the work.
8.3
EMPTY THE GRASS CATCHER
1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge door and hold it.
5. Hold the grass catcher by its handle and unhook it from
the slots.
6. Close the rear discharge door.
7. Empty the grass catcher.
8.4
OPERATE ON SLOPES
WARNING
Do not mow on the slopes with incline more than 15°. If
you are not comfortable, do not mow on a slope.
Do not go up and down on a slope, mow across the face
of the slope. Be careful when you change the direction on
a slope.
Monitor the holes, ruts, rocks, and other hidden objects
that can cause you to fall. Remove all obstacles such as
rocks and tree limbs.
Make sure that your footing is stable. If you are out of
balance, release the handle switch immediately.
Do not mow near drop-offs, ditches, or embankments.
8.5
OPERATION TIPS
Do not try to override the operation of the start button or
handle switch.
Do not tilt the machine when you start it.
Do not put hands or feet near or below the turning parts.
Keep the discharge chute clean.
Do not cut wet grass.
Higher blade height is necessary for new or thick grass.
English
Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
9
MAINTENANCE
Remove the safety key and battery pack from the machine
before maintenance.
Keep the motor and battery pack free from grass, leaves or
too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Recommended tightening torque (blade): 33-37 Nm.
9.1
GENERAL MAINTENANCE
Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
Tighten correctly all the fasteners and caps.
Clean the machine with a dry cloth. Do not use water.
11
WARNING
WARNING
CAUTION
CAUTION
CAUTION
NOTE
EN

Publicidad

loading

Este manual también es adecuado para:

Lmg301