Descargar Imprimir esta página

GreenWorks MO24B00 Manual Del Operador página 12

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
9.2
REPLACE THE BLADE
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade fully stops.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the blade nut (19) and spacer (18) with a impact
wrench or socket.
7. Remove the blade (17) and the positioner (21).
8. Position the new blade with the cutting edges toward the
ground .
9. Put on the blade nut and spacer, and tighten them with the
impact wrench.
9.3
STORE THE MACHINE
Clean the machine before storage.
Make sure that the motor is not hot when you store the
machine.
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
Replace the damaged parts.
Tighten the bolts.
Speak to a person of an approved service center.
Store the machine in a dry area.
21
19
17
18
WARNING
WARNING
English
Make sure that children cannot come near the machine.
10
TROUBLESHOOTING
Problem
The handle is not
in position.
The machine does
not start.
The machine cuts
grass unevenly.
The machine is
hard to push.
There is a high vi-
bration in the ma-
chine.
12
Possible cause
Solution
The bolts are not
Adjust the height
engaged correctly.
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
The battery ca-
Charge the battery
pacity is low.
pack.
The handle switch
Replace the handle
is defective.
switch.
The battery key is
Put in the battery
not put in.
key.
The lawn is rough. Examine the mow-
ing area.
The blade height is
Move the wheels
not set correctly.
to a higher posi-
tion.
The grass is too
Increase the blade
tall, or the blade
height.
height is too low.
The grass catcher
Empty the grass
and the blade
clippings from the
drags in thick
grass catcher.
grass.
The blade is un-
Replace the blade.
balanced and
worn.
The motor shaft is
1. Stop the mo-
bent.
tor.
2. Remove the
safety key and
battery pack.
3. Inspect for
damage.
4. Repair the ma-
chine before
you start it
again.

Publicidad

loading

Este manual también es adecuado para:

Lmg301