Fanimation FPD6228 Serie Manual De Instrucciones página 13

How to Assemble Your Light Kit or Cap
1. Remove one of the three screws in the adaptor
plate at the bottom of the motor assembly. Slightly
loosen the remaining two screws. Assemble the light
plate assembly to the adaptor plate of the motor
assembly using the two key slots in the light plate
assembly. Replace the third screw and secure all
three screws. (Figure 1)
2. Remove one of the three screws in the light plate
assembly and retain the screw for later. Slightly
loosen the remaining two screws. (Figure 2)
4A. (Option A--for use with light kit)
Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from motor
assembly. (Figure 4A)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
NOTE: If you have installed your fan with the steel
cap, skip Steps 5 and 6.
Light Plate
Assembly
Light Plate
Assembly
Light Kit
Wire Cover
LED
Assembly
Figure 4A
13
Motor
Assembly
Figure 1
Figure 2
Light Plate
Figure 3
Assembly
Steel Cap
Figure 4B