Fanimation FPD6228 Serie Manual De Instrucciones página 8

1. Remove the hanger ball
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for reinstal-
lation in Step 6. (Figure 1)
Remove the hairpin clip and clevis pin from the
2.
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
3. Route the black/white, blue, red, gray and yellow
wires and safety cable through the downrod.
4. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Install and tighten the
two set screws with nuts in the downrod support.
(Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
5. Route wires and safety cable
cover, canopy screw cover and ceiling canopy. (Figure 5)
How to Assemble Your Ceiling Fan
portion from the downrod/
(Figure 3)
through motor coupling
Downrod
Hanger Ball
Hairpin Clip
Downrod
Hairpin Clip
Ceiling Canopy
Canopy Screw
Cover
8
Pin
Set Screw
Figure 1
Clevis Pin
Figure 2
Black/White, Blue, Red,
Gray, Yellow wires and
Safety Cable
Figure 3
Set Screws and
Locking Nuts (2)
Clevis Pin
Figure 4
Motor Coupling
Cover
Figure 5