Maintenance
Storage drawer
44 English
NX7000K_VE_NX58M6850SS_AA_DG68-00909A-02_EN+MES+CFR.indb 44
1.
Slide open the drawer until it stops.
2.
Locate the roller guide clips on either
side. Using both hands, pull down the
left clip while lifting the right clip, and
then remove the drawer.
3.
Clean the drawer in warm, soapy water
using a cloth or soft brush. Then, rinse
and dry it thoroughly.
4.
Put the drawer in the roller guides on
either side, and then snap the clips into
place.
Troubleshooting
If you encounter a problem with the range, check the tables starting below, and
then try the suggested actions.
Checkpoints
Gas safety
Problem
Possible cause
You smell gas.
The surface burner knob
is not in the OFF position
and the burner is not lit.
There is a gas leak.
Surface burner
Problem
Possible cause
All burners do
The power cord is
not light.
not plugged into the
electrical outlet.
A fuse in your home may
be blown or the circuit
breaker tripped.
The gas supply is not
properly connected or
turned on.
Action
Turn the burner knob to OFF.
Clear the room, building, or area
of all occupants.
Immediately call your gas supplier
from a neighbor's phone. Do
not call from your phone. It is
electrical and could cause a spark
that could ignite the gas. Follow
the gas supplier's instructions.
If you cannot reach your gas
supplier, call the fire department.
Action
Make sure the electrical plug
is plugged into a live, properly
grounded outlet.
Replace the fuse or reset the
circuit breaker.
See the Installation Instructions
that came with your range.
2017-10-17
3:45:03