Publicidad
Preparation
• Only experience, practice and care can guarantee a good
welding job.
• The factor intervening in the welding process are many:
required current, distance between the electrode and the
work piece, soldering speed and direction, thickness and
type of the material, the work piece position, electrode
angle and also gauge, type of material and electrode
covering. Therefore, is advisable that before welding to
carry out practice some in scrap material to determine
which are the specific requirements needed for the job to
perform.
• The area on the work piece where the soldering will be
applied shall be clean, free of rust and paint.
• Joints between sheets with gauges higher than 1/8" shall
be beveled to have an adequate weld (A).
Welding
• Set the switch (B) into the ON (I) position. The
indicating light (E) will be illuminated.
• Turn the current adjusting control (C) until reaching the
amperes needed for the job.
• Hold the electrode holder or torch as comfortable as
possible. Bear in mind that during the welding process, the
angle, movement and distance regarding the work piece
shall be constant and uniform.
• Aim the electrode tip to the joint to be worked with to
generate the arc and start welding.
• Once the arc is lit start soldering keeping always the
electrode tip 0,08" away from the work piece. If you make
the weld having the electrode supported on the work
piece, it could adhere and the weld would have a low
quality.
• In case of overheating, the welder will stop functioning
and the thermal protection indicator light (D) will be lit.
Do not turn off the welder and wait until the indicator light
is off to use it again.
Slag Removal
• Upon finishing welding, use the wire brush included to
remove the slag from the weld bead surface.
CAUTION
• Wait until the slag has cooled down
and hardened to remove it.
• When hitting or brushing slag to remove it there can
be particles flying out. Wear eye protection and
keep bystanders away.
8
ENGLISH
Start Up
45°
60°
B
Supplies
For coated electrode processes (SMAW)
Type:
6013
Diameter: 3/32", 1/8"
Type:
7018
Diameter: 3/32"
Electrode Replacement
• When the electrode has been consumed 0.4" to 0.8"
away from the electrode holder, it is necessary to replace it
with a new one to keep on welding.
• Electrodes are burned in high
CAUTION
temperature. Do not try to manipulate the remains of the
electrode with your hand. Set the remains in a metal
container.
• Open the electrode holder nipper to hold the new
electrode by the end that is not covered. Do not hold the
electrode by the covered part.
A
45°
60°
45°
60°
C
E
D
Publicidad
