Audiovox VME 9512 TS Manual Del Usuario página 55

General
• Bluetooth - Bluetooth hands-free profile for safety / convenience and A2DP profile for streaming music from a PDA /
PMP and Mobilphone
• Navigation Ready (Nav101and NAV1352 TS)
• 38-Key Infrared Remote Control with 5-way Joystick
• One Composite Video Outputs for Additional Screens
• Compatible with LCM 972 TS Rear Seat Monitor with Touch Screen Interface
• One Audio / Video Auxiliary Input
• 200-Ohm Preamp Line Output - All Audio Channels
• 4VRMS Line Output - All Channels
• Rotary Encoder Audio Control
• Seven-Band EQ with Eight Preset EQ Curves
• Spectrum Analyzer
• Front, Rear, Center and Subwoofer Line Output
• Subwoofer Crossover and Phase Control
• Dolby Digital / Pro-Logic ll
• Programmable Volume Control
• Rear Camera Input (Normal and Mirror Image View)
• Auto TFT Dimmer
• 5-Way Joystick
Optional Equipment
• NAV101 / NAV 1352 TS
The VME 9512 TS is "navigation ready." Before accessing any navigation features, you must purchase and install the
NAV module. All installation and operating instructions will be included with the NAV navigation module. Once the NAV
is connected and operating properly, the NAV source mode will become active. While the NAV is not installed, the NAV
option appears gray, indicating the function is not available.
• Rear Camera
The VME 9512 TS is "camera ready." Before accessing any camera features, you must purchase and install a rear video
camera. Once the rear camera is connected and operating properly, the CAMERA source mode will become active.
While the camera is not installed, the CAMERA option appears gray, indicating the function is not available.
• DVB-T
See "DVB-T Opertation" on page 29.
• iPod
See "MP3/WMA Operation" on page 36.
• Bluetooth Phone
See "Bluetooth Operation" on page 43.
Tools and Supplies
You will need these tools and supplies to install your VME 9512 TS:
• Torx type, flat-head and Philips screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio (screwdriver, socket wrench set or other tools)
• Electrical tape
• Crimping tool
• Volt meter/test light
• Crimp connections
• 18 gauge wire for power connections
• 16 – 18 gauge speaker wire
Disconnecting the Battery
To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation.
55