Scheppach PL45 Traduccion Del Manual De Instrucciones Originales página 21

ACCESSORIES
Guide System
2 Piece Guide Rail 700 mm
1 Piece Rail Joiner
ACCESSORY PACKAGE (IT IS NOT A STANDARD PART
OF DELIVERY):
2 Pieces Screw Clamps
1 Piece Rebound Protection (Fence)
Guide Device (Fig. 10, 11)
The guide rails (A) enable clean, precise cuts
and protect the surfaces from damage.
When sawing with the guide rail, the cut depth is 4.5 mm
less than the scale value on the machine.
For safety, the guide rail can be secured with screw
clamps (B).
The rebound protection (D) ensures a safe guiding during
plunging
into the workpiece.
By means of the rail joiner (F), 2 guide rails can be con-
nected and
allow long, precise cuts
The guide clearance of the assembly on the guide rail can
be regulated
with the two adjustment screws (E).
With the offered accessories, miter cuts, corner cuts and
other fitting tasks can be carried out.
When first using this saw on the optional guide rail, it
will need to be adjusted to slide with minimal side
movement on the guide rail, Adjustable cams
(Fig 10 "E") are fitted to do this.
1. Place saw on guide rail.
2. Turn cams (Fig 10 "E") anti-clockwise until tight. Then
clockwise slightly to allow clearance. While holding
dials in position lock in place by screwing down the
Socket head Cap screws in the middle of each Cam
(5mm allen key supplied with machine)
3. Pull saw back and forth along rail ensuring it slides
smoothly Re-adjust as needed.
4. Future adjustment may be needed depending on use
of saw.
Caution!
Always secure the workpiece in such a way that it cannot
shift.
Always move the machine forward; never pull it toward the
body.
TO SAW:
1 Set the saw on the guide rail.
2 Switch on the machine.
3 Press the saw slowly down to the set cut depth and
move this evenly forward along the rail.
PLUNGE CUTS:
To Saw:
1 Set the saw on the guide rail at the marked cutting
point
2 Secure the rebound protection or fence (accessory not
included) at the back and front cut points on the guide
rail.
3 Switch on the machine.
4 Press the saw down slowly to the set cut depth and
move this forward evenly on the rail up to the front
cutting point.
MITRE CUTS:
For mitre cuts you should turn the two adjustment screws
(E) a half a turn to the right after placing the saw. This
helps avoid any unintentional tilting of the saw in the
slanted position. Only tighten the adjustment screws (E)
to the point where the saw can still be pushed along the
rails. This will help you avoid injury to the operator or
damage to the machine.
GB
19