LG LDP770 Serie Manual Del Propietário página 13

Preparing Cabinet Opening
This dishwasher is designed to fit a standard
dishwasher opening. An opening may be needed
on both sides to route plumbing and electrical
connections.
24" (610 mm) min.
33 / " (854 mm) min.
5
8
24" (610 mm) min.
1
Select a location as close to the sink as possible
for easy connections to water and drain lines.
2
To ensure proper drainage, install the
dishwasher no more than 12 ft. (3.65 m) from
the sink.
3
If installing the dishwasher in a corner, leave a
minimum of 2" (50 mm) between the dishwasher
and the adjacent wall.
4
To allow for proper clearance of plumbing and
electrical, use the template included with the
literature to determine the clearance on the side
of the cabinet where the cabinet meets the back
wall. Using a 2 / " diameter hole saw, drill a hole
1
2
in the target area as shown on the template.
WARNING
• Don't use existing holes unless they are in the
target area. Otherwise, the water supply and
drain hose may be damaged by being crushed
or kinked.
CAUTION
• Failure to properly locate the hole for the water
and drain lines may prevent the dishwasher from
installing flush with the cabinets and could result
in kinked or damaged lines. Installation damage
is not covered by the warranty, and leaks caused
by improper installation may result in property
damage.
• Where the cabinet opening is narrow, the
dishwasher must be carefully leveled and aligned
so that the dishwasher is supported fully by the
3 leveling legs and is not hanging from the upper
brackets. Failure to do so can result in leaks from
the front of the unit, AE errors, difficulty in closing
the door, or failure to operate.
For flush installations only, you may remove the
cabinet brace inside the cabinet.
9
4
INSTALLATION 13
Cabinet brace