Front Runner FADR001 Manual De Instrucciones página 3

2
FIT AND SECURE
2.1
2.2
2.3
510mm
355mm
FRONT
FADR001_REV_A00
1275mm
1115mm
Discard
Discard
3
Using a flat screw driver and starting from
the front of the vehicle, lift and remove the
two ditch moldings running along either side
of the roof.
Remove all the retaining clips using a long
nose plier as shown.
Lay the righthand ditch moulding on an
even surface. From the front tip of the ditch
moulding, measure and mark as shown.
Using a hacksaw, cut the ditch moulding at
each marking.
Discard the two smaller pieces and refit
the retaining clips to the three cut ditch
mouldings making sure the retaining clips
line up with the clip pins in the ditch.
Repeat this for the lefthand moulding.
© 2020 FRONT RUNNER VEHICLE OUTFITTERS