IMG STAGELINE TXS-606HT/2 Manual De Instrucciones página 8

Wireless Hand-held Microphone
These instructions are intended for users without
any specific technical knowledge . Please read these
instructions carefully prior to operation and keep
them for later reference .
All operating elements and connections de-
scribed can be found on the fold-out page 3 .
1 Overview
1 Display to indicate
1 . the channel group (GROUP 00 – 07)
2 . the channel (CHANNEL 00 – 99)
3 . the microphone sensitivity
(VOL −30 dB, −20 dB, −10 dB, 00 dB)
4 . the battery status
BATT
■
■
■
■
■
full
2 On / off switch
3 Screw sleeve
To access the operating elements (5) to (7) and
the battery compartment on the rear side, un-
screw the sleeve .
4 Threaded ring for the screw sleeve (3)
5 Buttons and

channel number and the microphone sensitivity
6 Button SET: To change the channel group, the
channel number or the microphone sensitivity,
press the button SET repeatedly until the corre-
sponding numerals start flashing on the display
(1) . While the numerals keep flashing, make the
settings with the buttons
7 Switch RF for the transmission power
position L: low transmission power (2 .5 mW)
position H: high transmission power (25 mW)
8 Sensor for the IR signals for automatic channel
setting
8
 
BATT
■
■
■
half-full
to set the channel group, the

and .
 
2 Important Notes
The wireless microphone corresponds to all relevant
directives of the EU and is therefore marked with
•
The microphone is suitable for indoor use only .
Protect it against dripping water, splash water
and high air humidity . The admissible ambient
temperature range is 0 – 40 °C .
•
For cleaning only use a dry, soft cloth; never use
water or chemicals .
•
No guarantee claims for the microphone and
no liability for any resulting personal damage or
material damage will be accepted if the micro-
phone is used for other purposes than originally
intended, if it is not correctly operated, or if it is
not repaired in an expert way .
BATT
discharged
3 Applications
To provide a wireless audio transmission system,
combine this dynamic hand-held microphone with
integrated multi-frequency transmitter with the
following receivers from IMG STAGELINE:
TXS-606 with 1 receiver unit
TXS-626 with 2 receiver units
TXS-646 with 4 receiver units
TXS-686 with 8 receiver units
The transmission frequency is freely selectable
within the UHF range 672 .000 – 691 .975 MHz
(frequency spacing 25 kHz) .
Due to the ACT function (automatic channel
targeting), the audio transmission system is very
easy to operate: Simply press a button and, via IR
signal, the wireless microphone is set to the chan-
nel selected on the receiver .
3.1 Conformity and approval
Herewith, MONACOR INTERNATIONAL declare that
the product TXS-606HT/ 2 complies with the direc-
tive 2014 / 53 / EU . The EU declaration of conformity
is available on the Internet:
www .img-stageline .com
Restrictions or requirements apply in the fol-
lowing countries:
The regulations of the country where the prod-
uct is operated must always be observed . Prior to
If the microphone is to be put out of
operation definitely, dispose of the mi-
crophone in accordance with local reg-
ulations .
CZ EL
IT LT
.
FI FR
MT PL