Troubleshooting Guide - Belle PCL X 320 Manual Del Operador

GB
WARNING
1
2
3
4
5
Stopping the engine
1. To stop the engine, set the throttle to idle. Allow the engine to idle for at least 2 minutes
2. Turn the engine ON / OFF switch anti-clockwise to the '0' position.
3. Turn the fuel off.
Starting the engine
1. Open the fuel tap by moving the fuel ON / OFF lever fully to the right.
2. If starting the engine from cold, set the choke ON by moving the choke lever fully to the right. If restarting a warm engine, the
choke is usually not required, however, if the engine has cooled to a degree, partial choke may be required.
3. Turn the engine ON / OFF switch clockwise to the 'I' position.
4. Set the throttle to the idle position by moving the throttle lever fully to the bottom.
5. Taking a ¿ rm hold of the control handle with one hand, grasp the recoil starter handle with the other. Pull the recoil starter until
engine resistance is felt, then let starter return.
6. Taking care not to pull the starter's rope fully out and pull the starter handle briskly.
7. Repeat until the engine ¿ res.
8. Once the engine ¿ res gradually set the choke lever to the OFF position by moving it to the left.
9. If the engine fails to ¿ re after several attempts, follow the trouble-shooting guide.
10. Due to the centrifugal clutch, the plate will not vibrate until the engine speed is increased.
GB
Problem
Engine will not start.
Engine still will not start
Unit will not vibrate.
Asphalt adhering to plate.
Bituminous surface
À aking (laminating).
Low travel speed
(plate sinking).
Operating Instructions
Before you operate or carry out any maintenance on this machine YOU MUST READ and STUDY
this manual.
7
6

Troubleshooting Guide

Cause
No fuel.
Engine switched off.
Spark plug fouled.
Engine cold.
Engine À ooded.
Major Fault
Engine speed too slow.
Drive belt tension loose.
Air ¿ lter blocked.
Drive failure.
Vibrator failure.
Lack of lubrication.
Over compaction.
Layer thickness too deep.
Moisture content too high or too low.
Honda GX100
1. Fuel Tank,
2. Choke Lever,
3. Fuel ON/OFF Lever,
4. Engine Oil Filler / Dipstick,
5. Throttle Lever,
6. Recoil Starter Handle,
7. Engine ON/OFF Switch
Remedy
Open fuel tap.
Fill fuel tank.
Switch engine on.
Clean and reset plug gap.
Close choke.
Open choke, fully open throttle, pull recoil starter until
engine ¿ res.
Contact Agent or Belle Group.
Set engine speed control to fast.
Adjust belt tension
Clean or renew air ¿ lter.
Contact Agent or Belle Group.
Contact Agent or Belle Group.
Use water
Remove and relay.
Remove some of the material.
Remove material and adjust.
12