Titan RX-80 Instrucciones De Uso página 4

Any static-electricity discharge from the spray gun is to be diverted to the
grounded high-pressure pump via the conductive high-pressure hose as
stipulated.
the maximum surface temperature corresponds to the permissible
material temperature. this and the permissible ambient temperature can
be found in the technical Data.
To avoid the generation of machine sparks, prevent impact stresses and any
work on the unit with tools in the explosion-hazardous area.
RESIDuAl RISkS
Residual risks are risks, which cannot be excluded, even when equipment is
used for the intended purpose.
In such cases the applicable areas of the actual residual risks will be pointed out
using warning and/or prohibition signs.
Risk Source / cause
Injection Atomized, high
injury pressure stream
of fluid
Explosion Static electricity
or fire or sparks
Hazardous Hazardous vapors
vapors from spray
material
tEcHNIcAl DAtA
max. operating pressure
material inlet thread size
Diffuser thread size
Wetted parts material
operating temperature range
maximum material temperature
maximum sound output
Weight
* Measurement location: 0.5 m away from the coating surface, 0.5 m behind
the spray gun, spray pressure 12 MPa, tip size 0.021
4
GB
Impact Preventative
measures
Severe NEVER aim the
injury or gun at any part of
amputation the body
Severe injury Use well
ventilated area
Ground the spray
gun
Severe injury Use well
ventilated area
Use mask
25 MPa (3600 PSI)
NPSM 1/4" (M16 x 1.5)
7/8 - 14 UN-2A
High-grade steel, aluminum, PTFE, hard metal
40ºF to 104ºF (5ºC to 40ºC)
109ºF (43ºC)
81 dB(A)*
599 g (1.3 lb.)
can occur
during:
Setup,
Operation
Operation
Operation
RX-80