VONROC CT502DC Traducción Del Manual Original página 10

EN
Maximum disc diameter
No load speed
Capacity of spring chuck
Weight
Lpa (Sound pressure level)
Lwa (Sound power level)
Vibration
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardised test given in EN 60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
- using the tool for different applications, or with
different or poorly maintainted accessories, may
significantly increase the exposure level.
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the following text refer to the
pictures on page 2-4.
1. Collet chuck
2. LED work light
3. Spindle lock
4A. Speed adjustment button "+"
4B. Speed adjustment button "-"
5. On/off button
6. Speed indication lights
7. Charger indication light
8. Chuck spanner
3. ASSEMBLY
Always make sure the machine is turned off
before mounting an accessory.
Warning! Change accessories by inserting
an accessory into the collet (or chuck) as far
possible to minimize run out and unbalance.
10
Ø35 mm
5.000–25.000/min
3.2 mm
0.26 kg
76+3 dB(A)
87+3 dB(A)
2.35+1.5 m/s
2
Assembly of accessories (Fig. B)
Press down the spindle lock (3) and hold it down.
Using the chuck spanner (8) you can undo the collet
chuck (1). Put the accessory in its place. Hold down
the spindle lock when you fasten the collet chuck
with the chuck spanner.
Do not press the spindle lock button while
the motor is running.
4. OPERATION
Switch on the machine by pressing the on/off
button (5).
With the speed adjustment button "+"(4A) or "-"(4B)
you can regulate the speed of the Combitool. Do not
put the machine down when the motor is still run-
ning. Do not place the machine on a dusty surface.
Dust particles may enter the mechanism.
Too high a load at a low speed of the
Combitool can burn out the engine.
The battery must be charged before first use.
Charging the device (with the charger)
• Plug the charger plug into an electrical outlet
and wait for a while. The charger indication light
(7) will lighten up and show the charging status.
LED Charger status
Red Battery charging in progress
Green Battery charging finished, battery fully charged
• After the battery is fully charged remove the
charger plug from the outlet and remove the
small plug from the device.
Holding and guiding the tool (Fig. C)
• For precision work (engraving): pencil grip (C1)
• For rough work (grinding): paring knife hand grip
(C2)
• When you need to keep the tool parallel to the
work surface (e.g. using a cut-off wheel): 2 hand
golf grip (C3)
Optimal use of the combi tool and its accessories
(Fig. A)
For optimal use of the accessories use the correct
speed. You can refer to the overview "Recommended
WWW.VONROC.COM