VONROC CT502DC Traducción Del Manual Original página 11

speed setting" below to determine the correct
speed, based on the material being worked on and
the type of accessory being used. This overview
enables you to select both correct accessory and
the optimum speed.
The 5 speeds indication lights (6) are equal to
the numbers 1, 2, 3, 4 and 5 in the overview
"Recommended speed setting".
Ultimately, the best way to determine the correct
speed for work on any material is to practice on a
piece of scrap.
RECOMMENDED SPEED SETTING
Grinding stones (Fig. D)
Material
Stone, shell
Steel
Aluminium, brass
Plastic
Felt wheels and tip (Fig. E)
The felt wheels or tip should be screwed on the
mandrel.
Material
Steel
Aluminium, brass
Plastic
Sanding bands and disc (sanding disc not included)
(Fig. F)
Material
Wood
Steel
Aluminium, brass
Plastic
Bristel brush (Fig. G)
Material
Stone, shell
Aluminium, brass
WWW.VONROC.COM
High speed cutter, Diamond wheel point and Drill
(Fig. H)
Abrasive disc (Fig. I)
Speed setting
5. MAINTENANCE
1-3
3-5
2-4
1-3
Keep the ventilation slots of the machine clean to
prevent overheating of the engine. Regularly clean
the machine housing with a soft cloth, preferably
after each use. Keep the ventilation slots free from
dust and dirt. If the dirt does not come off use a
Speed setting
soft cloth moistened with soapy water. Never use
3-5
solvents such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
2-4
Please clean the tool immediately after use.
3-5
ENVIRONMENT
Speed setting
4-5
Only for EC countries
1-3
Do not dispose of power tools into domestic
2-4
waste. According to the European Guideline
1-3
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
Speed setting
environmentally friendly way.
2-4
2-4
Material
Stone, shell
Steel
Aluminium, brass
Plastic
Material
Steel
Aluminium, brass
Plastic
Make sure that the machine is not live when
carrying out maintenance work on the motor.
Damaged and/or disposed of electrical or
electronic devices must be dropped off at
recycling stations intended for that purpose.
EN
Speed setting
5
2-4
4-5
1-3
Speed setting
3-5
2-4
1-3
11