Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning and Maintenance
Storage requirements
When the appliance is out of use for a
long period, set the expulsion tube to
parking position so that the appliance
takes up as little space as possible.
• To do this, bend the tube towards the
back of the appliance and secure it with
the diffusion hook, Fig. 24 and 25.
Fig. 24
Things to check before calling the Technical Service
General requirements for
operation
What to do if...
... the appliance does not work ...
• Check that it is plugged in properly.
• Check that the mains electricity supply is
working. Check the fuse box.
• Set the thermostat to its minimum
temperature position.
... the appliance does not work and the
symbol indicating that the condensed
water tank is full is displayed on the
screen ...
• Set the appliance on a flat surface. If the
symbol does not disappear, empty the
water tank. Make sure that the tank is
refitted properly afterw a rds. (See
i n s t ructions in "Cooling".
Fig. 25
Prior to use at change of season
• Clean the air filter.
• Clean the casing and the grilles if
necessary..
... the appliance does not reduce room
temperature sufficiently ...
• Check the joins on the hot air expulsion
tube.
• Make sure that the expulsion tube is not
too bent and that it is not extended to
m o re than 140 cm.
• Make sure that the plug is fitted on the
drainage water pipe.
• Fit the suction pad to close the window
as far as possible.
• Lower blinds to reduce direct sunlight.
... the fault symbol is displayed on the
screen ...
• Get in touch with an authorised dealer,
customer service or the manufacturer 's
Technical Service Network.
... there is water on the control panel
grille or on the basic filter housing ...
• There is no cause for concern. This is
normal.
66
Publicidad
