Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2609932778 04-11:BM 2609932778 04-11.qxp 3/31/11 7:40 AM Page 13
Service
Preventive maintenance
WARNING
performed by unauthorized
personnel may result in misplacing of
internal wires and components which
could
cause
serious
recommend that all tool service be performed
by a Bosch Factory Service Center or Autho-
rized Bosch Service Station.
TOOL LUBRICATION
Your Bosch tool has been properly lubricated
and is ready to use. It is recommended that
tools with gears be regreased with a special
gear lubricant at every brush change.
CARBON BRUSHES
The brushes and commutator in your tool
have been engineered for many hours of
dependable service. To maintain peak
efficiency of the motor, we recommend every
two to six months the brushes be examined.
Only genuine Bosch replacement brushes
specially designed for your tool should be
used.
If an extension cord is
WARNING
necessary, a cord with
adequate size conductors that is capable of
carrying the current necessary for your tool
must be used. This will prevent excessive
voltage drop, loss of power or overheating.
Grounded tools must use 3-wire extension
cords that have 3-prong plugs and receptacles.
NOTE: The smaller the gauge number, the
heavier the cord.
* Microfilter dust canister
** RS038 5" Soft backing pad
** RS6044 6" Extra-soft backing pad
** RS6045 6" Soft backing pad
** RS6046 6" Hard backing pad
* VAC024 Vacuum hose adaptor
** Polishing bonnet
All manuals and user guides at all-guides.com
Maintenance
Bearings which become noisy (due to heavy
load or very abrasive material cutting) should
be replaced at once to avoid overheating or
motor failure.
hazard.
We
the power supply before cleaning or
performing any maintenance. The tool may
be cleaned most effectively with compressed
dry air. Always wear safety goggles when
cleaning tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through openings.
parts. Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents,
ammonia and household detergents that
contain ammonia.
Accessories
RECOMMENDED SIZES OF EXTENSION CORDS
Ampere
Rating
** Foam buffing pad
** Replacement damper ring
** VAC005-VAC010 & VAC025 Vacuum hoses
** L-Boxx
(*= standard equipment)
(**= optional accessories)
-13-
BEARINGS
Cleaning
To avoid accidents always
WARNING
disconnect the tool from
Certain cleaning agents and
CAUTION
solvents damage plastic
120 VOLT ALTERNATING CURRENT TOOLS
Cord Size in A.W.G.
Tool's
Cord Length in Feet
25
50
100 150
3-6
18
16
16
14
6-8
18
16
14
12
8-10
18
16
14
12
10-12
16
16
14
12
12-16
14
12
—
—
2
Wire Sizes in mm
Cord Length in Meters
15
30
60
120
0.75 0.75 1.5
2.5
0.75 1.0 2.5
4.0
0.75 1.0 2.5
4.0
1.0 2.5 4.0
—
—
—
—
—
Publicidad
