Dyna-Glo DGH474CRN Manual De Instrucciones página 4

Safety Information
combustible construction or awnings.
Minimum clearance from sides and back
of unit to combustible construction, 36
inches (914.4mm) from sides and back.
NOTE: The installation must conform with
local codes or, in the absence of local
codes, with either the National Fuel Gas
Code, ANSI Z223.1/NFPA 54, Natural
Gas and Propane Installation Code, CSA
B149.1, or Propane Storage and Handling
Code, B149.2.
Do not store or use gasoline or other flammable liquids or vapors in the vicinity of this or any
other appliance.
An LP cylinder shall not be stored in the vicinity of this or any other appliance.
This grill is for use with natural gas only.
Never attempt to attach this grill to the self-contained propane system of a boat, camper
trailer, motor home or house.
Do not attempt to move the grill while it is lit or when it is hot. The casters should be locked
when not moving the grill.
Do not use the grill unless it is completely assembled and all parts are securely fastened and
tightened.
Do not touch metal parts of grill until it has completely cooled (about 45 minutes) to avoid
burns, unless you are wearing protective gear (pot holders, gloves, BBQ mittens, etc.).
Do not alter this grill in any manner.
Clean and inspect the hose before each use. If there is evidence of abrasion, wear, cuts, or
leaks, the hose must be replaced prior to operating the appliance. The replacement hose
assembly will be that which is specified by the manufacturer.
Move gas hoses as far away as possible from hot surfaces and dripping hot grease.
before each use. Do not obstruct the flow of gas or ventilation air.
properly assemble or safely operate the grill.
Do not leave a lit grill unattended. Keep children and pets away from the grill at all times.
Do not place this grill on any type of tabletop surface. The grill should be placed on a flat and
level surface.
Do not use the grill in high winds.
WARNING
36in
914.4mm
36in
914.4mm
CAUTION
4
36in
36in
914.4mm
914.4mm